Accurate Technology ProScale Manual de Instalação descarregar pdf (Página 13)

Manual Part # 800-1402-001 Rev E Page 13 of 48

The LCD

The above figure illustrates all the segments available on the LCD

Pressing and holding the ON/OFF and UNITS key for 10 seconds with

power OFF will perform a full segment LCD test, display the current

firmware version, AND RESET ALL PROGRAMMING PARAMETERS TO

FACTORY DEFAULT VALUES.

NOTE: The DRO may also be defaulted to original factory settings by removing

the battery and then pressing and holding the UNITS key while re-inserting

battery. *

* Internal jumper JP3 must be set to the Program Enable position to allow

the DRO to be reset to factory defaults as described above.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Sem comentários

Accurate Technology ProScale Manual de Instalação Página 13